Ausland CNC Series Fuel Injector Cleaner and Tester

AUSLAND CNC Injector Cleaner and Tester on Gasoline Cars Support 2/6 Cylinder Ultrasonic Fuel Injector Cleaning Machine for Cars/Motorcycle, 220/110V for Choosing.

The First One --- Ausland CNC200 Pro

Ausland CNC-200 Pro 2 Cylinders Fuel Injector Cleaner For Motorcycles test injector resistance ( one by one ), and display the data.

CNC200 PRO INJECTOR CLEANER FUNCTION:

1.To test injector resitance ( one by one ), and display the data ( NEW ).

2.Use PWM ( pulse width modulation ) to control and adjust fuel pressure( NEW ).

3.The special software for motorcycle injector ( NEW ).

4.To test the injecting angle and atomizing, to test the injector dribbling, to test the injector uniformity.

5.To test conduct the physical and chemical cleaning of the blocked or trouble injector, ultrasonic cleaning , test cleaning and on-vehicle cleaning.

6.To test and analyze the injector of operating mode and quality.

7.Can clean the Motorcycle engine without dismantling ( choose matched connector).

8.Can operate the auto static test, dynamic test and selective test with the injecting dribbling, angles, atomization, uniformity of one or more(1-2) injectors, can simulate any state of the vehicle to observe the complete process of injectors.

The Second One --- Ausland CNC600

Ausland CNC-600 gasoline 4/6/8 cylinder Auto Ultrasonic fuel injector cleaning machine 220V/110V

1 Ultrasonic cleaning: To perform simultaneous cleaning on several injectors and to remove the carbon deposits on the injector completely.

2 Uniformity/Sprayability test: To test the uniformity of injecting amount of each injector, and to monitor the spraying status of each injector with the help of backlight. This test is also for reverse flush.

3 Leakage test: To test the sealing and dribbling conditions of injectors under system pressure.

4 Injecting flow test: To check the injecting amount of the injector in 15 seconds of constant injection.

5 Auto test: To test injectors by simulating different working conditions.

6 On-vehicle cleaning: The unit is equipped with various adaptors and couplers that facilitate cleaning on the injectors on vehicle.

The Third One --- Ausland CNC600 Pro

Ausland CNC-600 Pro 6 cylinder FUEL injector cleaner test injector resistance ( one by one ), and display the data.

CNC600 PRO INJECTOR TESTER & CLEANER FUNCTION/FEATURES:

1.Can test injector resistance ( one by one ), and display the data.

2.Can test the defects of leaking, blocking, atomization, spray pattern, flow.

3.Solenoid valve drain the liquid to tank, have LED of backlight.

4.Cumulative testing and engine simulation testing.

5.Using pulse width modulation to control and adjust fuel pressure.

6.Have Auto function, manual function.

7.Ultrasonice cleaning, can set the working time, the max time is one hour, at the same time the injector is working.

8.Can test and clean GDI,FSI,SIDI,MPI,SPFI,TBI,CFI,K-JET,LPG,Motorbike-injector,including high or low resistance injector.

9.The display for LED.

Suggestions and precautions for use:
1. Alternative test fluid: Aviation kerosene. Or non-corrosive, and non-viscous liquid. 1-1.5 liters
2. Alternative cleaning solution: metal cleaning powder and water
3. Working time: 10-15 minutes
4. Ultrasonic cleaner 1.8 liter capacity, liquid cannot exceed 2/3 of the volume, and working less than half an hour